Quote:
|
Originally Posted by Mike Dodson
Mike,
I use a measuring tool that is called proportional dividers. You simply check your reference with one end of the dividers and make your mark on your canvas or paper using the opposite. The center screw can be adjusted to what ever ratio you desire. Attached is a commercial set. I use a set that I made. I typically mark a vertical and horizontal line across the center of my reference and then do the same on my canvas. I then measure everything from the center of the two "cross-hairs" and transfer the measurements over. You just simply use the opposite end of the dividers that you are measuring with to make your mark on the canvas. The accuracy is dead on.
|
Hi Mike.
I believe this is "The Tool".
I am working on one too. Since you have made one yourself I would like to ask what size you think is the optimal. The length of the legs ????
I have measured on my model, and think that about 15" is close to what I need.
Allan