|
corrections
Here's a picture of the drawing after a couple more hours, all I've done is correct a few mistakes to the outline. The most obvious bit I got wrong is the length of the nose.
Steven, you asked me to shout out when I found myself in error, well here it comes: I've just realised that I'm not 90 degrees to my drawing board, so I have perspective on my drawing, with a vanishing point somewhere off to the left of me. The right half of the drawing is bigger than the left, or at least it will be when I look at it flat on. Does that make sense to anyone else or have I lost it?
I'm glad I decided to do these in stages, I can make sure I get this right on the next one. Being as I'm only going up to schematic stage with this one, I'm going to finish it off anyway.
It's funny, the camera was trying to tell me this all along, it's why I can't set horizontal guides across the image and have them line up on the shots, why my drawing always looks bigger than the cast in the photos. I suppose I should apologise to my camera now, but just a little bit.
Unfortunately the light is going now and I'm away for a few days from tomorrow, so I'll continue with this one when I get back.
|
Threaded Mode
