Portrait Artist Forum    

Go Back   Portrait Artist Forum > Methods of Seeing
FAQ Community Calendar Today's Posts Search


Reply
 
Topic Tools Search this Topic Display Modes
Old 06-24-2006, 06:47 PM   #21
Ilaria Rosselli Del Turco Ilaria Rosselli Del Turco is offline
Juried Member
 
Ilaria Rosselli Del Turco's Avatar
 
Joined: Apr 2004
Location: London,UK
Posts: 640



Thanks Mischa, that is very clear. I am very motivated to do it seriously.
More questions: which paper? Simple Fabriano liscia ? Is there anything else I need?
The book is arriving just two days before I leave and I am an early packer and won't be able to run around in art shops at the last minute anyway.
I used to do graphite work when I started my illustration course, using points as sharp as needles and a very light hand. I hope I will be able to do it again, haven't been working like that for twenty years...
Ilaria
__________________
Ilaria Rosselli Del Turco
  Reply With Quote
Old 06-24-2006, 09:07 PM   #22
Mischa Milosevic Mischa Milosevic is offline
Juried Member
FT Professional
 
Joined: Dec 2005
Location: Bad Homburg, Germany
Posts: 707
Ciao Ilaria, I wish I was going to Italy. I hope to stop in to get some Umbria the end of August. You can get all the supply's you need in Italy except the kneaded rubber I prefer. Sharp point and a light hand is what you will use here as well. So, you of to a good start. ;-)

we used a light toned of white Canson. Not to much tooth but enough to hold the graphite. Think about a smooth finish rather than the grainy look.
Sand paper pad,
Knife to sharpen your pencils.
2B 7mm led and led holder work fine.
A board to tape your paper on side by side,
string for measuring, make sure the string does not stretch and red is good
ruler to draw the plumb line with but all measuring is done with the string and by eye
kneaded rubber I prefer Design 1225 brand, it if soft but it is firm when you need a sharp edge. others are to soft. do not get a white kneaded rubber
a pencil type eraser that you can sharpen
a #2 da Vinci synthetic brush which you fill trim to a length of half a cm
a soft stomp

I think this is all you will need.

Think about copying a simple figure line drawing as well, good one to start with is Plll, 1&3. You can tape these on the other side of your board.

If you have any questions in regard to the proper setup, how to get started just let me know.

All the best
  Reply With Quote
Old 06-25-2006, 03:30 PM   #23
Chris Saper Chris Saper is offline
SENIOR MODERATOR
SOG Member
FT Professional, Author
'03 Finalist, PSofATL
'02 Finalist, PSofATL
'02 1st Place, WCSPA
'01 Honors, WCSPA
Featured in Artists Mag.
 
Chris Saper's Avatar
 
Joined: Jun 2001
Location: Arizona
Posts: 2,481
Dear Ilaria,

I don't know how you would overcome the perspective distortion by working at other that a vertical easel.
__________________
www.ChrisSaper.com
  Reply With Quote
Old 06-26-2006, 12:56 PM   #24
Ilaria Rosselli Del Turco Ilaria Rosselli Del Turco is offline
Juried Member
 
Ilaria Rosselli Del Turco's Avatar
 
Joined: Apr 2004
Location: London,UK
Posts: 640
Well, I was just trying to be lazy and get away with it, my easel is spoiled, it loves to come on holiday in Tuscany every year...
I.
__________________
Ilaria Rosselli Del Turco
  Reply With Quote
Old 06-26-2006, 05:29 PM   #25
Allan Rahbek Allan Rahbek is offline
Juried Member
 
Allan Rahbek's Avatar
 
Joined: Mar 2004
Location: 8543-dk Hornslet, Denmark
Posts: 1,642
Ilaria,
You could use the cabinet door and tape the ref and drawing side by side.
Have a nice holiday.
Allan
  Reply With Quote
Old 06-27-2006, 08:51 PM   #26
Linda Brandon Linda Brandon is offline
Juried Member
 
Linda Brandon's Avatar
 
Joined: Jul 2001
Location: Phoenix, AZ
Posts: 1,734
Hi Ilaria,

When I'm on vacation, I just tape my Bargue 2D studies to the wall someplace and sneak away to work on them when nobody wants me for anything.
__________________
www.LindaTraceyBrandon.com
  Reply With Quote
Old 06-27-2006, 11:02 PM   #27
Carol Norton Carol Norton is offline
Juried Member
 
Carol Norton's Avatar
 
Joined: May 2004
Location: Phoenix, Arizona
Posts: 281
Bargue Plates

Ok, Bargue Groupies, how do I obtain/buy these wonderful training drawings? I use the airport, and other down-times to draw from life, but I'd love to have these wonderful training devices when I'm not out among 'em.
  Reply With Quote
Old 06-28-2006, 08:41 AM   #28
Mischa Milosevic Mischa Milosevic is offline
Juried Member
FT Professional
 
Joined: Dec 2005
Location: Bad Homburg, Germany
Posts: 707
On The Move Art Training, vacation the airport etc.

If anyone wishes to get the most out of the Bargue drawings then they should not think that this can be done while on the move. I speak from experience. If you think otherwise you are or have shortchanged your self. The Bargue drawings need more attention than one can give while on the fly.

When on the move, I recommend, take with you a A5 sketch pad, 2B pencil, a kneaded eraser, and with these and the John H. Vanderpoel The Human Figure book in you hand, you will receive the training that you are looking for. You will, if you draw all the sample drawings in this book. Another excellent training tool is shape exercises.

Sincerely yours,
mischa
  Reply With Quote
Reply


Currently Active Users Viewing this Topic: 1 (0 members and 1 guests)
 

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is Off
HTML code is Off

Forum Jump

 

Make a Donation



Support the Forum by making a donation or ordering on Amazon through our search or book links..







All times are GMT -4. The time now is 05:01 PM.


Powered by vBulletin® Version 3.8.6
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.